t5 wireing question

[jollopee]

I bought vossloh schwabe moisture proof end caps and was looking at the thing but I can seem to find how or where to wire this up or if the plug in wire harness from my original light just plugs into these endcaps? Anyone have any experience with these endcaps??

Todd

[Meric]

The wires connect in the bottom of the end caps. On my ballast One endcap has yellow wires and one end cap is either red or blue (I have dual lamp ballast)

[farmer_dan]

Can I ask where you bought the end caps? Are they for sure water proof (they have rubber O rings, one that screws into the end cap and one the the bulb goes through). Normally you just take the bared wire about .625" stripped back and push it into the squared socket from the bottom that will lock it in, be carful as once in very hard to remove without wrecking the endcap. But follow the ballast wiring diagram. Good Luck.

Taylor