How to install/uninstall waterproof end caps?

Seafan · 04-27-2002, 11:04 AM

Hello,

I just got some German 3-piece water-proof end caps for fluorescent lights from PA.

There are no instructions with them.

Are the wires supposed to go to the bottom of the end cap, the two side compartments? If that's the case, and I'd like to test it first, how do I pull the wires out? (so it wouldn't break anything or loosen the contact)

thanks,

Jason

Rin · 04-27-2002, 11:18 AM

There should be a slot where you can fit a jewler's screwdriver and move the copper spring to the side. Then the wire should lift right out.

(Your pics didn't come across.)

04-27-2002, 11:04 AM	#1
Seafan Citizen Join Date: Sep 2000 Location: New Orleans, LA, USA Posts: 152	How to install/uninstall waterproof end caps? Hello, I just got some German 3-piece water-proof end caps for fluorescent lights from PA. There are no instructions with them. Are the wires supposed to go to the bottom of the end cap, the two side compartments? If that's the case, and I'd like to test it first, how do I pull the wires out? (so it wouldn't break anything or loosen the contact) thanks, Jason __________________ Welcome to visit my web site Aquarist Report

04-27-2002, 11:18 AM	#2
Rin Mayor Join Date: Dec 2000 Location: Leesburg, GA Posts: 774	There should be a slot where you can fit a jewler's screwdriver and move the copper spring to the side. Then the wire should lift right out. (Your pics didn't come across.) __________________ -Todd

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)